Da-Lite Multi Format Imager Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Projektionswände Da-Lite Multi Format Imager herunter. Curved-Multi-Format-Imager-Instructions - Da-Lite Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken

Inhaltsverzeichnis

Seite 1 - Curved Multi Format Imager

INSTRUCTION BOOK FOR Curved Multi Format Imager

Seite 2 - Pre-Installation

10Multi Format Imager Wiring DiagramMulti Format Imager OperationConnect IR eye to splitter for screen operation. IR eye shall be plugged into a QEYE

Seite 3 - Da-Snap Frame Assembly

11Multi Format Imager Intermediate Stop AdjustmentMulti Format Imager Limit Travel Adjustment1. To adjust intermediate stopping positions make sure b

Seite 4 - Figure 3 Figure 4

12Multi Format Imager Limit Travel Adjustment (Continued)6. Locate the two tactile buttons on the back of the switch. They are square silver with bla

Seite 5 - Figure 6

13Symptom Cause Solution Masking System will not operate. Motor does not hum.Incorrect line voltage.Verify 115125V (or 220240V). If insuicient volt

Seite 8 - Figure 12

LIMITED ONE YEAR WARRANTY ON DALITE PRESENTATION PRODUCTSMilestone AV Technologies LLC warrants certain Da-Lite branded products to the original purc

Seite 9 - Figure 13

2Tools Required for InstallationImportant Safety InstructionsWhen using your video equipment, basic safety precautions should always be followed, incl

Seite 10 - Multi Format Imager Operation

31. Inside each box the frame pieces will be individually paper wrapped and taped. Remove all paper from pieces. Do not use a utility knife to remov

Seite 11 - Figure 17 Figure 18

4Curved Multi Format Imager Assembly1. Lay frame pieces out on the loor or table as shown in Figure 2. The bottom frame assembly has the junction bo

Seite 12

54. Assemble bottom end of left frame assembly to end of bottom frame assembly. The large L-bracket will slide into the aluminum extrusion while the

Seite 13 - Troubleshooting

69. Route the two cable assemblies around motor bracket and plug the 3 wire male connector into the 3 wire female connector on the motor bracket.

Seite 14

7Curved Multi Format Imager AssemblySlat BarSafety Cable Passes Through Middle of SpringBlack Knob (4 or 6 For Top BracketsBlack Knobs (4 or 6 For Bo

Seite 15

8Figure 12Curved Multi Format Imager Installation – Wall Mount1. The screen is shipped with one wall hanger board. Two small brackets are included to

Seite 16

91. To connect power to unit locate junction box cover on bottom frame assembly. There will be two black screws holding the wiring box cover on as sh

Kommentare zu diesen Handbüchern

Keine Kommentare