INSTRUCTION BOOK FOR ViewShare Advantage Electrol Retroit
10Installation of ViewShare Screen and Roller Assembly (continued)10. Remove the USB to CAT5 extender labeled “Remote” from the shipping carton. At t
11Camera and Speakerphone InstallationThe following components are necessary and included for camera and speakerphone installation. • Local CAT5 to U
12Camera and Speakerphone Installation (continued)Camera and Speakerphone SetupYou are now ready to run the initial camera setup. The computer will re
13TroubleshootingVisit www.da-lite.com to ind installation and troubleshooting tutorials. You will also ind a link to Live Chat for interactive supp
14Appendix A: Screen Adjustment for Type 1 Motor (HV suix in Part Number)TYPE 1 MOTORHas manual limit adjustments on end of motor4-wire connectionT
15Appendix A: Screen Adjustment for Type 2 Motor (LT suix in Part Number)No manual limit adjustments on end of motorRJ22 cable3-wire connectionTYPE
16Appendix A: Screen Adjustment for Type 3 Motor (LS suix in Part Number)TYPE 3 MOTORNo manual limit adjustments on end of motorRJ45 cable3-wire co
17Appendix B: Arm Adjustment1. When screen is lowered approximately six inches below the case, the elbows of the arms should be horizontally aligned
19
2Tools Required for InstallationImportant Safety InstructionsWhen using your video equipment, basic safety precautions should always be followed, incl
LIMITED WARRANTY – VIEWSHARE PRODUCTSMilestone AV Technologies LLC warrants its Da-Lite branded ViewShare products to the original purchaser only, to
3Removal of Old Screen and Roller Assembly1. Run the screen to the up position. 2. Remove the access door by removing the screws from each end (Figu
4Pre-Installation of ViewShare Screen and Roller Assembly1. Remove existing motor and pin end roller assembly brackets from inside the case. NOTE: A
5Transfer of Existing Motor1. Remove motor from the old screen and roller assembly and set aside (Figure 9). NOTE: Try to avoid turning the rubber c
6Transfer of Existing Motor (continued)Figure 114. Completely remove both shipping brackets from the board.5. Remove the three Phillips head screws
7Transfer of Existing Motor (continued)Figure 13Figure 14Retainer ClipMotor PlugWood Block8. Carefully lift the roller above the mounting bracket and
8Installation of ViewShare Screen and Roller AssemblyNOTE: The ViewShare screen and roller assembly, which includes brackets and arms, must be install
9Installation of ViewShare Screen and Roller Assembly (continued)Figure 17Figure 18Black LBracketElectrical Connection6. Remove black L-bracket on p
Kommentare zu diesen Handbüchern